(1. 東華理工大學 核資源與環境國家重點實驗室，南昌 330013；
2. 西安藍曉科技新材料股份有限公司，西安 710000)
摘 要: 用二乙烯三胺對丙烯酸聚合物進行改性，再用氯甲烷甲基化制備一種新型的離子交換樹脂SLX-D11，系統研究樹脂對廢水中U(Ⅵ)的吸附行為，重點考察了pH、U(Ⅵ)初始質量濃度、吸附時間和溫度等因素對其吸附的影響。采用BET、SEM-EDS、FTIR對吸附前后的樹脂進行表征，并對吸附機理進行探討。結果表明：在室溫下樹脂投加量為0.02 g、pH為5.0、U(Ⅵ)質量濃度為250 mg/L的條件下反應15 h，其飽和吸附量達175.21 mg/g。該吸附過程符合準二級動力學模型和Langmuir模型，且吸附是自發吸熱過程，升溫有利于樹脂對U(Ⅵ)的吸附。在U(Ⅵ)質量濃度為250 mg/L、流速為0.3 mL/min條件下，當流經液為215個床體積時樹脂吸附達到飽和；選用0.5 mol/L NaCl和0.5 mol/L H2SO4混合溶液作解吸液進行解吸，相同流速下28個床體積的解吸液能將柱床上的U(Ⅵ)完全解吸。因此，SLX-D11離子交換樹脂作為分離回收廢水中U(Ⅵ)的吸附材料，具有吸附量大、富集倍數高、選擇性高等特點，比較適用于環境廢水中U(Ⅵ)的回收，具有一定的應用前景。
關鍵字: 氨基；丙烯酸樹脂；U(Ⅵ)；吸附
（1. State Key Laboratory of Nuclear Resources and Environment, East China University of Technology, Nanchang 330013, China;
2. Sunresin New Materials Co., Ltd., Xi’an 710000, China）
Abstract:A new type of ion exchange resins SLX-D11 was prepared by modification of acrylic polymer with diethylenetriamine and methylation of chloromethane. The effects of pH, initial mass concentration of U(Ⅵ), adsorption time, temperature and other factors on its adsorption efficiency were investigated by static batch experiments.BET, SEM-EDS and FTIR were used to characterize the resins before and after adsorption. The results show that the saturated adsorption capacity reaches 175.21 mg/g when resins dosage is 0.02 g, pH is 5.0, mass concentration of U(Ⅵ) is 250 mg/L and adsorption time is 15 h. The adsorption behavior can be precisely described by the pseudo-second-orderkinetic model and Langmuir isothermal model. In addition, the adsorption is a spontaneous endothermic process, and temperature rise is beneficial to adsorption of U(Ⅵ) by SLX-D11resins. Under the condition that the mass concentration of U(Ⅵ) is 250 mg/L and the flow rate is 0.3 mL/min, the adsorption reaches saturation when the flow volume reaches 215 bed volumes. The mixed solution of 0.5 mol/L NaCl and 0.5 mol/L H2SO4 is selected as desorption solution. At the same flow rate, the desorption solution of 28 bed volumes can completely desorbed U(Ⅵ) on the column bed. So, as a adsorption material for separating and recovering U(Ⅵ) from the wastewater, SLX-D11 ion exchange resins has the characteristics of large adsorption capacity, high enrichment ratio and high selectivity. It is applicable to the recovery of U(Ⅵ) from environmental wastewater and has certain application prospects.
Key words: amino; acrylic resins; U(Ⅵ); adsorption
