(南昌航空大學 航空制造工程學院，南昌 330063)
摘 要: 采用環壓縮實驗研究LF2M鋁合金薄壁管材在應變速率為0.1~1 s-1，成形溫度為350~475 ℃條件下的應力-應變行為。提出一種薄壁環壓縮的方法，得到薄壁管材熱壓下的變形行為。結果表明：環壓縮試樣的高度選擇需要避免壓縮過程中出現起皺缺陷。試樣高厚比為1時，隨著壓縮量增加，切向壓應力超過臨界值引起起皺失穩；試樣高厚比為3時，隨著壓縮量增加，壓應力超過臨界值，出現起皺現象；試樣的高厚比為2時，壓縮后試樣無起皺缺陷。因此，壁厚為1 mm時，環壓縮試樣的最佳高度為2 mm。LF2M鋁合金薄壁管材熱變形過程中的流變應力可用雙曲正弦本構關系來描述，平均激活能為160.67 kJ/mol。
關鍵字: LF2M鋁合金；薄壁環；熱壓縮；高厚比；本構關系
（School of Aviation Manufacturing Engineering, Nanchang Hangkong University, Nanchang 330063, China）
Abstract:The stress-strain behavior of LF2M aluminum alloy of thin-walled tube during hot compressing deformation was studied, under the conditions of strain rate range of 0.1-1 s-1, and the temperature range of 350-475 ℃. A method of thin-walled ring compression was proposed to obtain the deformation behavior of the thin-walled tube under hot extrusion. The results show that the height of the ring compression sample is selected to avoid wrinkling defects during the compression process. When the ratio of the height to thickness is 1, with the increase of the amount of compression, the tangent pressure exceeds the critical value caused to the wrinkling destabilization. When the ratio of the height to thickness is 3, the compression stress exceeds the critical value caused to the wrinkling destabilization with the increase of the amount of compression. When the ratio of the height to thickness is 2, the specimen have no wrinkling destabilization. Therefore, when the wall thickness is 1mm, the optimum height of the ring compression specimen is 2 mm. The flow behavior of LF2M aluminum alloy of thin-walled tube is described by the hyperbolic sine constitutive equation, and an activation energy of 160.67 kJ/mol is calculated.
Key words: LF2M aluminum alloy; thin-walled ring; hot compression; ratio of height to thickness; constitutive relation
