(中南大學 粉末冶金國家重點實驗室，長沙 410083)
摘 要: 采用濕化學法制備W-3%ZrC-0.3%Y2O3(質量分?jǐn)?shù))材料，研究該材料在1800~1920 ℃的燒結致密化行為，通過與W-3ZrC材料及純鎢材料燒結態力學性能和顯微組織的對比研究，分析復合添加ZrC和Y2O3對鎢材料強韌化的作用和意義。結果表明：W-ZrC-Y2O3材料的致密度和抗拉強度均呈現出隨燒結溫度升高先增加后降低的趨勢，其相對密度和抗拉強度均在1860 ℃達到最大值，分別為97.8%、446 MPa；添加第二相粒子能有效細化鎢材料的晶粒，Y2O3/ZrC復合添加較單一ZrC能更有效細化鎢晶粒，晶粒由W-3ZrC的10 μm降低至5~8 μm。復合強化相粒子改變了斷裂過程中裂紋擴展的形狀和長度，起到強化和韌化作用。
關鍵字: 第二相粒子；復合強化；晶粒細化；致密度
（State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China）
Abstract:The composite materials of W-3%ZrC-0.3%Y2O3 (mass fraction) were prepared by wet chemical methods. The densification behavior was studied when the composite materials was sintered at 1800-1920 ℃. By comparing with mechanical properties and microstructure of W-3ZrC materials and pure tungsten material, the function and meaning of compounding adding ZrC and Y2O3 were researched. The results show that the relative density and intensity increase at first, and then decrease with increasing sintering temperature. And the relative density and tensile strength reach 97.8% and 446 MPa, respectively, when sintered at 1860 ℃. The second phase particles can effectively refine the grain size of tungsten material, and the composite adding Y2O3/ZrC is more effective. The grain decreases from 10 μm of W-3ZrC to 5-8 μm of W-3ZrC-0.3Y2O3. The composite strengthening phase particles can change the shape and length of crack propagation, which proves that ZrC and Y2O3 are helpful to improve the strength and toughness of composites.
Key words: second phase particles; composite reinforcement; grain refinement; density
