(1. 北京科技大學 機械工程學院，北京100083；2. 哈爾濱工業大學 材料科學與工程學院，哈爾濱 150001)
摘 要: 通過真空退火處理得到具有不同β相含量的TA15板材，并對其進行室溫單軸拉伸試驗，獲得不同β相含量板材的真應力-應變曲線，并采用Bridgman公式對頸縮階段應力進行了修正。結果表明：隨著β相含量的增加，拉伸斷裂應變明顯增大。分別考慮α與β相室溫變形行為，基于連續損傷力學建立了一套耦合位錯密度和微觀損傷的單軸拉伸本構模型。通過不同β相含量試樣的應力-應變曲線，采用遺傳算法確定本構方程常數。利用β相含量為18.63%和20.04%的試樣的應力-應變曲線對所建模型進行驗證，計算值與試驗值吻合較好。
關鍵字: TA15鈦合金；塑性損傷；位錯密度；本構模型；遺傳算法
（1. School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China;
2. School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China）
Abstract:The sheet specimens of TA15 sheet with different volume fractions of β phase were obtained by vacuum annealing. Then, the stress-strain curves of sheet with different volume fractions of β phase were obtained by tensile test at room temperature, and the true stress after necking was corrected through the well-known Bridgman equations. The results indicate that the tensile strength increases slightly with the volume fraction of β phase. With increasing volume fraction of β phase, the fracture strain increases significantly. Considering the flow behavior of two phases, respectively, a set of constitutive equations coupling dislocation density and damage based on the continuum damage mechanics were developed. The model constants were determined using genetic optimization algorithm (GA). The stress-strain curves of the sheet with 18.63% and 20.04% β phase were used to evaluate the proposed model. The good agreements between the experimental and computed results are obtained.
Key words: TA15 Ti alloy; ductile damage; dislocation density; constitutive model; genetic algorithm
