(1. 西北工業大學 凝固技術國家重點實驗室，西安 710072；
2. 北京航空制造工程研究所，北京 100024)
摘 要: 對TC17合金在820和860 ℃下進行等溫鍛造，隨后在相同溫度下進行熱處理10 min~8 h，利用定量金相法研究變形量、熱處理溫度等工藝參數對片狀α相靜態球化的影響規律。結果表明：隨著變形量的增加，在隨后熱處理過程中片狀α相更容易發生晶界分離而形成球化組織，球化速率明顯提高。溫度影響擴散過程，對靜態球化有促進作用，且在應變較低時影響更為明顯。在球化率隨熱處理時間增大的同時，球化速率逐漸減小至常值，JMAK方程可以用來描述TC17合金靜態球化的規律。
關鍵字: TC17合金；靜態球化；等溫鍛造；熱處理
（1. State Key Laboratory of Solidification Processing, Northwestern Polytechnical University, Xi’an 710072, China;
2. Beijing Institute of Aviation Manufacturing Engineering, Beijing 100024, China）
Abstract:The isothermal compression of TC17 alloy at 820 and 860 ℃, and subsequently annealing for 10 min-8 h were conducted, and the effects of deformation degree, annealing temperature and annealing time on static globularization of TC17 titanium alloy were investigated. The results show that the deformation degree greatly influences the boundary splitting, so that the static globularization kinetics of α phase increases with increasing deformation degrees. As a thermally activated process, the diffusivity of solutes is determined by annealing temperature. Thus, the static globularization can be accelerated by increasing the temperature, especially when the strain is low. Meanwhile, globularization ratio increases while static globularization kinetics decrease to a constant with increasing the annealing time. The JMAK equation can be used to describe the static globularization kinetics.
Key words: TC17 titanium alloy; static globularization; isothermal compression; heat treatment
