(1. 青島大學 化學化工與環境學院，青島 266071；
2. 西安交通大學 理學院，西安 710049)
摘 要: 采用溶體快淬法制備(Mg60Ni25)100-xLax(x=4, 6, 8, 10)的非晶貯氫合金帶，分別采用X射線衍射儀和高分辨透射電鏡對該合金在充放氫循環過程中的組織結構進行表征。結果表明：Mg65Ni27La8合金具有最高的放電容量(582 mA？h/g)，充放電(吸釋氫)過程可分為以下4個階段：1) 氫原子被非晶相吸收，氫原子的分布是無序的；2) 隨著吸氫過程的繼續，合金中逐漸出現直徑小于4 nm的HT-Mg2NiH4和LT-Mg2NiH4兩種氫化物，且數量逐漸增加；3) 隨著氫化物開始分解釋氫，分解后局部結構恢復到無序態，僅留下一些尺寸較大且較為穩定的LT-Mg2NiH4納米晶；4) 剩余的氫原子從非晶相中釋放，表現為非晶相的釋氫，在此過程中合金的結構無顯著變化。
關鍵字: Mg-Ni-La系貯氫合金；顯微結構；電化學性能；溶體快淬
（1. College of Chemistry, Chemical and Environmental Engineering, Qingdao University, Qingdao 266071, China;
2. School of Science, Xi’an Jiaotong University, Xi’an 710049, China）
Abstract:(Mg60Ni25)100-xLax(x=4, 6, 8, 10) amorphous alloys were prepared by melt-spinning. The phase structures of the ribbons before and after charge/discharge cycling were characterized by X-ray diffractometry (XRD) and high-resolution transmission electron microscopy (HRTEM), respectively. The results show that Mg65Ni27La8 has the maximum discharge capacity of 582 mA？h/g, and its absorption/desorption process can be divided into the following four stages: 1) the hydrogen atoms are absorbed by the amorphous phase, and the distribution of the hydrogen atoms is disordered; 2) with further hydrogen-absorbing, two hydrides of HT-Mg2NiH4 and LT-Mg2NiH4 with a diameter of less than 4 nm form gradually and their numbers increase; 3) beginning with the release of hydrogen, the local structure the decomposition after returns to the disorderly state, leaving only some of the large size and relatively stable LT-Mg2NiH4 nanocrystals; and 4) the remaining hydrogen atoms release from the amorphous phase, and the structure of the alloy in the process has no significant change.
Key words: Mg-Ni-La hydrogen-storage alloy; microstructure; electrochemical property; melt-spinning
