(1. 北京有色金屬研究總院 有色金屬加工中心，北京 100088；
2. 北京科技大學 材料科學與工程學院，北京 100083；
3. 鞍山鋼鐵集團公司，鞍山 114021；
4. 西南鋁業(集團)有限責任公司，重慶 401326)
摘 要: 采用熱壓縮試驗、方差分析和TEM技術研究變形條件對2099合金流變行為的影響規律和組織演化特征。結果表明：隨著應變的增加，2099合金流變應力經歷了過渡變形和穩態變形兩個階段。在顯著性水平為0.01條件下，變形溫度和應變速率對2099合金流變應力的影響高度顯著，表明該合金為正的應變速率和負的變形溫度敏感性材料。且隨著應變的增加、變形溫度的升高和應變速率的降低，合金組織依次經歷了無規則的位錯纏結→多邊形化→晶界弓出形核+亞晶合并→再結晶晶粒長大過程。當變形溫度為460 ℃、應變速率為0.01 s-1、應變量為1.1時，合金可獲得細小的再結晶組織。
關鍵字: 2099合金；應變；變形溫度；應變速率；方差分析
（1. Nonferrous Metals Processing Division, Beijing General Research Institute for Non-ferrous Metals, Beijing 100088, China;
2. School of Materials Science and Engineering, University of Science and Technology Beijing, Beijing 100083, China;
3. Anshan Iron and Steel Group Corporation, Anshan 114021, China;
4. Southwest Aluminum (Group) Co., Ltd, Chongqing 401326, China）
Abstract:The effects of deformation conditions on flow behaviors and microstructure evolution characteristics of 2099 alloy were investigated by hot compression tests, variance analysis and TEM technology. The results show that, the flow stress of 2099 alloy experiences two stages with the increase of strains, namely, the transition deformation stage and the steady deformation stage. The effects of temperatures and strain rates on the flow stress are significant under the significance level of 0.01, which indicates that 2099 alloy is a positive strain rate sensitive and negative temperature sensitive materials. The microstructure of 2099 alloy experiences irregular dislocation tangles → polygonization → grain boundaries bulging + subgrains coalescence → dynamic recrystallization grain growth with increasing the strains and temperatures and decreasing the strain rates. And the fine recrystallized microstructure of 2099 alloy can be obtained under the deformation conditions of temperature 460 ℃, strain rate 0.01 s-1 and stain 1.1.
Key words: 2099 alloy; strain; deformation temperatures; strain rates; variance analysis
