(1. 新疆工程學院 化學工程系，烏魯木齊 830091；
2. 新疆工程學院 基礎部，烏魯木齊 830091
3. 新疆工程學院 組織人事處，烏魯木齊 830091；
4. 哈爾濱慶緣電工材料有限股份公司，哈爾濱 150001)
摘 要: 采用液相共沉淀法和固相燒結法分別制備鎳鈷錳復合氫氧化物(Ni0.5Co0.2Mn0.3(OH)2)和LiNi0.5Co0.2Mn0.3O2正極材料。通過X射線衍射和電化學性能測試對所得樣品的結構及電化學性能進行了表征。結果表明：LiNi0.5Co0.2Mn0.3O2具有很好的α-NaFeO2層狀結構，以20 mA/g的電流密度在2.5~4.3 V的電壓區間充放電時，最高首次放電比容量達175 mA?h/g, 首次庫倫效率在89%~90%之間。當首次放電比容量為160~170 mA?h/g時，30循環未見容量衰減。鋰含量對其電化學性能影響的結果表明：鋰含量(n(Li)/n(Ni+Co+Mn))在1.03~1.09的范圍內，隨著鋰含量的增加，放電比容量略有減小，但循環性能、中值電壓以及平臺性能都得到提高；當鋰含量超過1.09時，循環性能、中值電壓以及平臺性能開始降低。
關鍵字: 鋰離子電池；正極材料；LiNi0.5Co0.2Mn0.3O2；電化學性能
（1. Department of Chemical Engineering, Xinjiang Institute of Engineering, Wulumuqi 830091, China;
2. Department of Basic, Xinjiang Institute of Engineering, WuLuMuQi 830091, China;
3. Organi）
Abstract:The nickel and cobalt manganese composite hydroxide(Ni0.5Co0.2Mn0.3(OH)2) and LiNi0.5Co0.2Mn0.3O2 cathode materials were prepared by the solid state sintering synthesis and liquid phase coprecipitation. The structure and electrochemical performance were characterized by X-ray diffractometry and electrochemical properties test. The results show that the cathode material LiNi0.5Co0.2Mn0.3O2 has α-NaFeO2 structure. The highest initial discharge capacity is 175 mA?h/g at current density of 20 mA?h/g in 2.7-4.3 V (vs Li/Li+), while the coulombic efficiency is 89%-90%. When the initial discharge capacity is at the range of 160-170, the capacity does not fade after 30 cycles. When n(Li)/n(Ni+Co+Mn) are 1.03-1.09, the discharge specific capacity decreases little with molar ratio of Li to M increasing. When molar ratio of Li to M is bigger than 1.09, the cycling performance, mean voltage and discharge plateau begin to fade.
Key words: Li-ion battery; cathode material; LiNi0.5Co0.2Mn0.3O2; electrochemical properties
