(北京科技大學 機械工程學院，北京 100083)
摘 要: 針對目前金屬鎂熱還原工序中人工裝出料的現狀，提出采用無軸螺旋體作為罐內執行機構的機械裝出料方式。通過理論設計計算確定螺旋體的結構、尺寸和運動參數，采用ANSYS有限元分析螺旋體的整體彎曲和扭轉性能，以保證機構設計參數合理并具有良好的機械性能。研究表明：通過對葉片截面溫度場的分析發現，葉片在工作時間內的溫升在材料的允許范圍內，驗證所選葉片材質的合理性；通過對螺旋體的應力分析，發現自由端葉片和螺旋內徑處為薄弱環節，提出螺旋體自由端的縮徑結構和外窄內寬的梯形葉片截面。采用本機構進行機械化裝出料，可將裝出料時間由2 h縮短為15 min，大大縮短熱還原工序的時間，具有實際推廣和應用價值。
關鍵字: 鎂熱還原；高溫裝出料；機械化；無軸螺旋
（School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China）
Abstract:In traditional thermal reduction process of magnesium, charging and discharging were carried out in manual operation. Based on this, the screw structure without shaft was proposed as the actuator inside the reduction jar. The corresponding structure sizes and motion parameters were determined by theoretical calculation. The bending and torsion stress were analyzed by the finite element analysis of ANSYS software, which can guarantee feasible parameters designed and good mechanical property of the structure. By analyzing the temperature distribution of blade section, the temperature changes of blade during the working time are in the range of material allowed, which proves that the blade material is available. The blades at free end and at inner periphery are weak by the stress analysis. Therefore, a diameter shrinkage structure at free end and blade with trapezoid cross section are presented. The results show that, by applying the screw structure without shaft, the time for charging and discharging is shortened from traditional 2 h to 15 min, which shows the designed structure with practical value is worth popularizing.
Key words: thermal reduction of magnesium; high-temperature charging and discharging; mechanization; screw structure without shaft
