(1. 中南大學 冶金科學與工程學院，長沙 410083；
2. 中國鋁業股份有限公司鄭州研究院，鄭州 450041)
摘 要: 采用超聲活化對原材料Li2CO3和TiO2進行預處理，并采用二步煅燒方法制備Li4Ti5O12材料。利用X射線衍射儀、掃描電鏡和電池充放電測試儀研究二步煅燒條件對材料結構、形貌及電化學性能的影響，并得到二步煅燒的最佳工藝。結果表明：采用600 ℃預燒溫度制備的材料具有較高的純度和結晶度；800 ℃高溫煅燒溫度下制備的Li4Ti5O12材料具有均一分散的顆粒結構；超聲活化制備Li4Ti5O12的最佳煅燒工藝是600 ℃預燒8 h后800 ℃高溫煅燒10 h，制備的材料在0.1C倍率下首次放電容量達170.6 mA∙h/g，0.2C倍率下20次循環后的放電比容量由152 mA∙h/g降至150 mA∙h/g，容量保持率為98.7%。
關鍵字: Li4Ti5O12；超聲活化；二步煅燒；鋰離子電池
（1. School of Metallurgical Science and Engineering, Central South University, Changsha 410083, China;
2. Zhengzhou Research Institute of CHALCO, Zhengzhou 450041, China）
Abstract:Li2CO3 and TiO2 raw materials were pretreated by ultrasonic, then Li4Ti5O12 materials was prepared by two step calcination process. The effects of the synthesizing conditions on the crystalline structure, morphology and electrochemical properties were studied by XRD, SEM and cell charge/discharge performance test, and the best process was obtained. The results shows that the material synthesized at low calcined temperature of 600 ℃ shows a high crystallization and purity, the material synthesized at high calcined temperature of 800 ℃ shows a well-distributed structure. The best process for the preparation of Li4Ti5O12 is low calcined temperature of 600 ℃ for 8h sequentially high calcined temperature of 800 ℃ for 10 h, and the first discharge specific capacitance of the material at 0.1C is 170.6 mA∙h/g, and after 20 cycles at 0.2C, the specific capacitance decreases from 152 mA∙h/g to 150 mA∙h/g with a retention rate of 98.7%.
Key words: Li4Ti5O12; ultrasonic mixing; two step calcination; Li-ion battery
