Transactions of Nonferrous Metals Society of China The Chinese Journal of Nonferrous Metals

您目前所在的位置:首頁 - 期刊簡介 - 詳細頁面

中國有色金屬學報

ZHONGGUO YOUSEJINSHU XUEBAO

第21卷    第5期    總第146期    2011年5月

[PDF全文下載]        

    

文章編號:1004-0609(2011)05-1087-06
電沉積納米晶Ni-Co-Fe合金鍍層的熱穩定性
林綠波1, 林蘭芳2, 戴品強1, 3, 廖耀祥1, 鄭瑜濱1

(1. 福州大學 材料科學與工程學院,福州 350108;)

摘 要: 用脈沖電沉積方法制備表面平整光亮的納米晶Ni-Co-Fe合金鍍層。采用XRD、TEM、EDS、DSC和顯微硬度計分別研究納米晶Ni-Co-Fe合金鍍層的微觀結構、化學成分、熱穩定性及其硬度。結果表明:納米晶Ni-Co-Fe合金鍍層的晶體結構為單相的面心立方結構,其晶粒尺寸隨鍍層Co含量的增加而減小;合金鍍層的顯微硬度隨退火溫度的升高而提高,在300~375 ℃時達最大值,存在明顯的退火再強化,之后,隨著退火溫度的繼續升高明顯下降;當鍍層在低于375 ℃退火時,晶粒長大速度較慢;而當鍍層在高于450 ℃退火時,晶粒迅速長大,并呈現較強的(111)織構。升溫速率為20 ℃/min時,納米晶Ni-Co-Fe合金鍍層的DSC結果顯示,晶粒長大的峰值溫度隨鍍層Co含量的增加而升高。由Kissinger方程求得納米晶Ni-Co-Fe合金的晶粒長大激活能隨鍍層Co含量的增加而增大。

 

關鍵字: 脈沖電沉積;納米晶;Ni-Co-Fe合金;熱穩定性;激活能

Thermal stability of electrodeposition nanocrystalline
 Ni-Co-Fe alloy coatings
LIN LÜ-bo1, LIN Lan-fang2, DAI Pin-qiang1, 3, LIAO Yao-xiang1, ZHENG Yu-bin1

1. College of Materials Science and Engineering, Fuzhou University, Fuzhou 350108, China;
2. College of Marine Engineering, Jimei University, Xiamen 361021, China;
 3. Department of Materials Science and Engineering, Fujian University of Technology, Fuzhou 350108, China

Abstract:Nanocrystalline Ni-Co-Fe alloy coatings with smooth and bright surface were synthesized by pulsed electrodeposition. The microstructure, chemical composition, thermal stability and hardness of the coatings were studied by XRD, TEM, EDS, DSC and microhardness tester, respectively. The results reveal that the grain size of the nanocrystalline Ni-Co-Fe alloy coatings with FCC structure decreases with increasing the content of Co in the coatings. The microhardness of Ni-Co-Fe alloys increases with the increase of the annealing temperature after annealed at low temperatures, and reaches the peak value at 300−375 ℃, showing a significant hardening during annealing, and the hardness decreases with increasing the annealing temperature further. The grain grows slowly when the annealing temperature is lower than 375 ℃, while the rapid grain growth occurs during annealing above 450℃, showing a strong (111) texture. The DSC results obtained at the heating rate of 20 ℃/min show that the peak temperature value for the grain growth in nanocrystalline Ni-Co-Fe alloy coatings increases with increasing the content of Co in the coatings. The activation energy obtained from the Kissinger equation for the grain growth of Ni-Co-Fe alloy coatings increases with increasing content of Co in alloy coatings.

 

Key words: pulse electrodeposition; nanocrystalline; Ni-Co-Fe alloys; thermal stability; activation energy

ISSN 1004-0609
CN 43-1238/TG
CODEN: ZYJXFK

ISSN 1003-6326
CN 43-1239/TG
CODEN: TNMCEW

主管:中國科學技術協會 主辦:中國有色金屬學會 承辦:中南大學
湘ICP備09001153號 版權所有:《中國有色金屬學報》編輯部
------------------------------------------------------------------------------------------
地 址:湖南省長沙市岳麓山中南大學內 郵編:410083
電 話:0731-88876765,88877197,88830410   傳真:0731-88877197   電子郵箱:f_ysxb@163.com  
三亚市| 崇州市| 霍城县| 轮台县| 绥德县| 深州市| 新邵县| 延吉市| 双峰县| 怀宁县| 读书| 甘孜县| 太湖县| 易门县| 琼中| 诸城市| 堆龙德庆县| 长沙市| 喜德县| 抚远县| 慈利县| 陈巴尔虎旗| 抚顺县| 临清市| 台北市| 永新县| 会同县| 金堂县| 周口市| 新巴尔虎左旗| 和林格尔县| 祁门县| 青冈县| 蒲江县| 德阳市| 平乐县| 海宁市| 尤溪县| 中阳县| 安康市| 雅江县|