(廣東工業大學 材料與能源學院，廣州 510006)
摘 要: 采用銅模吸鑄工藝制備出直徑為3 mm的Cu50.4Ti27.1Zr16.2Co6.3和Cu50.9Ti27.4Zr16.4Co5.3非晶圓棒，用X射線衍射、差示掃描量熱儀、掃描電子顯微鏡、能譜分析儀和振動樣品磁強計研究非晶合金的熱穩定性、結構組織、相成分和磁性能。結果表明：當升溫速率為20 ℃/min時，該兩種非晶合金的過冷液相區分別為59 K和41 K；在磁性元素含量較小的銅合金體系中，小范圍變化Co含量對飽和磁化強度的影響不大；樣品直徑由3 mm增大到5 mm時，非晶基體中會析出較多形狀不規則富Co和Ti的混合相，使樣品的飽和磁化強度Ms明顯增大。
關鍵字: CuTiZrCo塊體非晶合金；玻璃形成能力；深共晶點；磁性能
（Faculty of Materials and Energy, Guangdong University of Technology, Guangzhou 510006, China）
Abstract:Cu50.4Ti27.1Zr16.2Co6.3 and Cu50.9Ti27.4Zr16.4Co5.3 amorphous rods with diameter of 3 mm were prepared by copper mold suction casting process. Their thermal stability, microstructures, phase compositions and magnetic properties were detected by X-ray diffractometer (XRD), differential scanning calorimeter (DSC), scanning electron microscope(SEM), energy dispersive spectrum (EDS) and vibrating sample magnetometer(VSM). The results show that, at a heating rate of 20 ℃/min, the supercooled liquid regions of the two bulk metallic glasses are 59 K and 41 K, respectively. The small-scale change of Co content in the Cu-based alloy system has little effect on the saturation magnetization (Ms). When the diameters of the samples increase from 3 mm to 5 mm, the magnetic phase with rich Co and Ti precipitates in the amorphous matrix. Then, the saturation magnetization (Ms) of the samples significantly increases.
Key words: CuTiZrCo bulk metallic glass; glass forming ability; deep eutectic point; magnetic properties
