(1.鞍山鋼鐵學院化學工程研究中心，鞍山114002；
2.北京科技大學冶金部腐蝕-腳損與表面技術開放研究實驗室，北京100083)
摘 要: 在自行研制的腐蝕磨損試驗機上，研究了腐蝕學因素對化學鍍Ni-P合金腐蝕磨損行為的影響。結果表明，當NaCl濃度為3. 5%時，化學鍍Ni-P合金的腐蝕磨損速率、摩擦系數和腐蝕磨損協同作用率具有峰值特性。Nacl濃度升高將引起Ni-P合金的自腐蝕電位負移，溫度升高將引起Ni-P合金的腐蝕磨損速率增大，協同作用率上升。化學鍍Ni-P合金可以作為G105鋼在NaCl溶液中抵抗腐蝕磨損的表面改性材料。
關鍵字: 氯化鈉 化學鍍 Ni-P合金 腐蝕磨損 協同作用
（1.Chemical Engineering Research Center，Anshan Institute of Iron and Steel Technology,Anshan 114002;
2.Bei jing University of Science and Technology,Beijing 100083）
Abstract:The effect of corrosion factors on the corrosive wear behaviours of electroless Ni-P coating in NaCl solution was studied using a device made by authors. The results showed that electroless Ni-P coating had better of wear than G105 steel,and the main loss forms were the pure mechanical wear and the synergy between corrosion and wear.
Key words: electroless plating Ni-P coating corrosive wear synergy NaCl solution
