(北京航空材料研究院,北京 100095)
摘 要: 在Ti-(44～48)Al-(3～6)Cr(摩爾分?jǐn)?shù), %) 的三元合金中，存在B2結構的體心立方有序β2 相，其形成與含Cr量有關。β2相鑄態成分可表示為：Ti55Al33Cr12。β2相是該合金中顯微硬度最高的相，其硬度值隨合金中Cr 含量增加而提高。β2相常分布于γ 晶界，起阻礙晶粒長大作用。
關鍵字: TiAl基合金 β2相 Cr的作用
（Institute of Aeronautical Materials, Beijing 100095, P. R. China）
Abstract:In the ternary alloys of Ti-(44~48)Al-(3~6)Cr(mole fraction, %), there is an ordered bccβ2 phase with B2 structure. The formation of this phase is related to the content of Cr. 0.5%(volume fraction) β2 phase can be precipitated in as-cast Ti-44Al-3Cr alloy. The amount of β2 phase reaches 6%(volume fraction) after long time soaking from 900 ℃ to 1200 ℃. However, β2 phase disappears when holding long time above 1250℃. The composition of β2 phase can be expressed as Ti55Al33Cr12. The microhardness of β2 phase is the highest among all the phases of the alloy and its microhardness increases with the increase of Cr content in alloys. β2 phase often distributes at the grain boundaries of γ phase and retards the growth of γ phase grains. The deformation capability of β2 phase is the weakest in the phases of the alloy and it inhibits the long distance slip, therefore, β2 phase would make slip dispersive and delay the initiation of cracks.
Key words: TiAl base alloys β2 phase effect of Cr
