(1 北京科技大學新金屬材料國家重點實驗室，北京 100083; 2 北京理工大學，北京 100022)
摘 要: 單相Al-2Mg合金在300~530℃ 以0.069~1.587s-1形變速率扭轉到真應變5.5， 隨后立即水冷。 采用真應力-真應變曲線，偏振光金相和透射電子顯微鏡研究該合金熱扭轉過程的動態復原機制。試驗證實，該合金熱扭轉過程中發生了動態再結晶，但在一定的Z 參數范 圍內發生，Z 參數過大或過小，只發生動態回復。顯微組織分析并沒有發現層錯的存在。發生動態再結晶的原因是動態回復被抑制，即在較高形變溫下，加大形變速率，而在較低形變溫度下，降低形變速率。
關鍵字: Al-2Mg合金；動態再結晶；熱扭轉
（State Key Laboratory for Advanced Metals and Materials,
University of Science and Technology Beijing, Beijing 100083, P.R.China
Beijing Institute of Technology，Beijing 100022，P.R.China）
Abstract:Specimens of single phase Al-2Mg alloy have been deformed by hot torsion at 300~530℃ and strain rates of 0.069~1.587 s-1 to true strain of 5.5 followed by water quenched immediately. The dynamic restoration mechanisms during hot torsion were examined by the true stress-true strain curves，optical and electron microscopy. It has been shown that dynamic recrystallization occurs in certain range of parameter Z. If Al-2Mg alloy is deformed by torsion out of the range， only dynamic recovery occurs. The microstructural observations indicate that there are not the regions of stacking faults in the matrix. The occurrence of dynamic recrystallization results from the depression of dynamic recovery，i. e. increasing strain rate at higher temperature and reducing strain rate at lower temperature.
Key words: alaminium-magnesium alloys；dynamic recrystallization；hot torsion tests
