(中國科學院金屬腐蝕與防護研究所，金屬腐蝕與防護國家重點實驗室，沈陽 110015)
摘 要: 為采用較合適的工藝條件獲得滿足一定力學性能的泡沫鎳產品，以有機泡沫電沉積法為基礎，探討了幾種具體工藝條件對所得產品抗拉強度的影響。結果表明，在氨分解氣氛中980 ℃為時40 min的燒結之前，預加一個600 ℃為時4 min的空氣燒解以及將燒結溫度降低到850 ℃，對最終產品的抗拉強度基本沒有影響。保持上述工藝條件不變，導電化處理時涂覆約1μm厚的石墨基導電膠或化學鍍約3μm的鎳層（含P量約5% ），所得產品的抗拉強度也基本相同。
關鍵字: 泡沫鎳 抗拉強度 工藝條件
（State Key Laboratory for Corrosion and Protection, Institute of Corrosion and Protection of Metals,
The Chinese Academy of Sciences, Shenyang 110015, P. R. China）
Abstract:Effect of different technology conditions on tensile strength of the nickel foam produced by electrodeposition on the organic foam has been investigated, and it was found that the tensile strength was hardly influenced by burning in air at 600 ℃ for 4 min before hand, and lowering the sintering temperature to 850 ℃, then sintering in NH3 decomposition atmosphere at 980 ℃ for 40 min; and besides above yet done whether by coating a graphite-base conductive colloid layer about 1μm thick or by chemically plating a Ni-P alloy (about 5%P) layer about 3 μm thick.
Key words: nickel foam; tensile strength; technology condition
