(1. 洛陽工學院 材料工程系， 洛陽 471039;
2. 西安交通大學 機械工程學院， 西安 710049)
摘 要: 在對ZA12合金鎢極氬弧焊接頭HAZ不同部位(測點)焊接熱循環曲線大量測試和計算基礎上，借助于焊接熱模擬技術，設計了進行焊接HAZ顯微組織模擬的熱循環參數，并在DM1000A型電阻加熱式熱模擬試驗機上，實現了ZA12合金鎢極氬弧焊焊接HAZ加熱峰值溫度 θm=370 ℃, 305 ℃區域(測點)顯微組織的模擬。研究結果表明：ZA12合金鎢極氬弧焊焊接HAZ組織熱模擬試樣的耐磨性均高于母材，并均隨負荷的增加其耐磨性降低。焊接HAZ組織熱模擬試樣的耐磨性與其組織中α相內共析體組織形態密切相關。
關鍵字: ZA12合金； 鎢極氬弧焊；焊接HAZ； 組織模擬； 摩擦學性能
（1. Department of Material Engineering， Luoyang Institute of Technology，Luoyang 471039, P.R.China;
2. Department of Mechanical Engineering， Xi′an Jiaotong University，Xi′an 710049, P.R.China）
Abstract:Base on a vast amount of testing and calculations for the welding thermal cycling curves of different testing points in HAZ(heat affected zone) of ZA12 alloy TIG welding joint， the thermalcycle parameters of microstructure stimulation of welding HAZ were designed ， and the microstructure simulation of testing points (θm is 370 ℃ and 305 ℃) of ZA12 alloy by TIG welding was carried out by the means of type DM1000A ohmicheating welding thermal simulation tester. The study results from the simulation specimen indicated that the wear resistance of welding HAZ of ZA12 alloy in comparison with that of base metal increases in varying degrees， and with loadincreasing the wear resistance decreases. The wear resistance of the simulation specimens of welding HAZ was closely related to theform of eutectoid microstructure in α phase.
Key words: ZA12； TIG welding； welding HAZ； microstructure simulation； tribological properties
