(西北工業大學 材料學院，西安 710072)
摘 要: 采用箔−纖維−箔法制備SiCf/Ti6Al4V/Cu復合材料，研究Ti6Al4V在連續SiC纖維增強Cu基復合材料中作界面改性涂層時的界面反應結合特征。利用光學顯微鏡、掃描電鏡和能譜儀分析復合材料顯微組織、斷口形貌以及SiCf/Ti6Al4V界面和Ti6Al4V/Cu界面的反應擴散特征。結果表明：該復合材料的抗拉強度并沒有顯著提高；SiCf/Ti6Al4V界面反應非常微弱；而Ti6Al4V/Cu界面反應非常明顯，主要是Ti原子與Cu原子之間的反應，反應層厚度約為20 μm；反應產物主要呈4層分布，分別為CuTi2、CuTi、Cu4Ti3和Cu4Ti。
關鍵字: SiC纖維；Ti6Al4V/Cu界面；銅基復合材料；界面反應
SiCf/Ti6Al4V/Cu composite
（School of Materials Science and Engineering, Northwestern Polytechnical University, Xi’an 710072, China）
Abstract:SiCf/Ti6Al4V/Cu composite was prepared by foil-fiber-foil method in order to study the interfacial reaction and bonding characteristics when Ti6Al4V was used as interfacial modification coating on the continuous SiC fiber reinforced copper matrix composites. The microstructure, fracture surface, SiCf/Ti6Al4V interface and Ti6Al4V/Cu interface were studied by optical microscopy (OM), scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). The results show that the tensile strength of the composites is not improved distinctly. The SiCf/Ti6Al4V interfacial reaction is very weak, while the Ti6Al4V/Cu interfacial reaction is obvious, with about 20 μm thick reaction layer, which occurs mainly between Ti and Cu atoms. The reaction products distribute in four layers, which are CuTi2, CuTi, Cu4Ti3 and Cu4Ti.
Key words: SiC fiber; Ti6Al4V/Cu interface; copper matrix composites; interfacial reaction
