(湖南大學 材料科學與工程學院， 長沙 410082)
摘 要: 研究了耐熱鋁合金Al-8.7Fe-1.6V-1.3Si(8009)的固液混合鑄造。結果表明：采用固液混合鑄造工藝制備的耐熱鋁合金顯微組織明顯細化，室溫和高溫力學性能明顯優于鑄造和攪拌鑄造耐熱鋁合金。固液混合鑄造坯具有良好的擠壓性能，擠壓坯具有優異的室溫和高溫耐磨性能。在本工藝條件下，當粉末添加質量和合金熔體質量比為1時，耐熱鋁合金中的Al13Fe4析出相粒徑可控制在30μm以下，材料的室溫力學性能為：σb=210MPa，00.2=190MPa，δ=4％；在473K時為：σb=150MPa，σ0.2=130MPa，δ=5%；在573K時為：σb=110MPa，σ0.2=90MPa，δ=6%。
關鍵字: 固液混合鑄造；耐熱鋁合金；半固態加工
processing of Al-8.7Fe-1.6V-1.3Si
elevated temperature alloy
ZHANG Fu-quan，HU Zhong-xun，F(xiàn)U Jie-xing
（College of Materials Science and Engineering，
Hunan University，Changsha 410082，China）
Abstract:A novel mixed solid-liquid casting technology was utilized to prepare elevated temperature aluminum alloy (8009). The results show that, comparing with conventional casting processing and stirring casting process，this process can effectively refine the grains and precipitated Al13Fe4 phase particles and can obviously improve the room temperature or high temperature mechanical properties. Better extrudability，abrasive resistance at room temperature and high temperature can also be obtained by this process. When mass ratio of the alloy powder to the melt is up to 1，the mean size of the Al13Fe4 particles in the alloy samples can be controlled under 30μm; its mechanical properties at room temperature is σb=210MPa，σ0.2=190MPa，δ=4%; at 473K，σb=150 MPa，σ0.2=130MPa，δ=5%；at 573K，σb=110MPa，σ0.2=90MPa，δ=6%.
Key words: mixed solid-liquid casting; elevated temperature aluminum alloy; semi-solid processing
