(大連理工大學 化工學院， 大連 116012)
摘 要: 采用電化學測試技術研究了人體醫用金屬材料工業純鈦和Ti6Al4V合金在人工模擬體液中的腐蝕行為。結果表明，陽極極化后兩種合金均未發現點蝕，工業純鈦的維鈍電流密度小于Ti6Al4V合金，前者的陽極極化性能優于后者。Ti6Al4V合金縫隙試樣在陽極電位超過+2 000 mV(vs SCE)后，電流開始急劇增大，發生了縫隙腐蝕; 通過電子探針分析發現，在縫隙內Al和V兩種元素發生活性溶解。工業純鈦在電位達到+4 000 mV(vs SCE)時仍沒有發生縫隙腐蝕。
關鍵字: 人體醫用金屬材料； 工業純鈦； Ti6Al4V合金；腐蝕行為
Ti6Al4V alloy in artificial body fluid
（School of Chemical Engineering, Dalian University of Technology,
Dalian 116012， P.R.China）
Abstract:The corrosion behavior of surgery medical materials commercially pure Ti (abridged as CPTi ) and Ti6Al4V alloy in Ringer's artificial body fluid was studied with electrochemical methods. The results show that no pitting corrosion is found on these two alloys. The passivation current density of CPTi is lower than that of Ti6Al4V， which indicates that the former's anodic polarization capacity is better than the latter's. With the polarization potential over than 2 000 mV(vs SCE)， the crevice corrosion happens on Ti6Al4V alloy sample. However that is not found on CPTi sample when the potential is 4 000 mV(vs SCE). The EPMA analysis of Ti6Al4V alloy crevice corrosive sample shows that Al and V actively dissolve， then migrate and electrically deposit.
Key words: surgery medical materials; commercial pure Ti; Ti6Al4V alloy; corrosion behavior
