(1. 哈爾濱工業大學 材料科學與工程學院， 哈爾濱 150001;
2. 哈爾濱理工大學 材料科學與工程學院， 哈爾濱 150080)
摘 要: 利用XDTM法與攪拌鑄造技術相結合的工藝制備了TiCp/Zn-10Al(%)復合材料，采用定向凝固技術研究增強粒子TiCp在凝固界面的行為及對復合材料凝固速度的影響。結果表明：TiC顆粒被凝固的界面前沿所排斥，造成界面前沿TiC顆粒富集，但當TiC顆粒含量超過6%后，富集現象已不顯著。同時發現隨著TiC顆粒含量的增加，復合材料的凝固速度降低。
關鍵字: TiCp/Zn-10Al；復合材料； 定向凝固； 凝固速度
of Zn-10Al alloy
WANG Li-ping２
（1. School of Materials Science and Engineering， Harbin Institute of Technology，Harbin 150001， P.R.China;
2. School of Materials Science and Engineering, Harbin University of Science andTechnology，Harbin 150080， P.R.China）
Abstract:TiCp/Zn-10Al(%) composites was fabricated by XDTM and stirringcasting techniques. The behavior of reinforcement TiC particle in the solidification interface and its effect on the solidification velocity of composites were studied by the directional solidification. The results show that TiC particle is pushed by the solidification front, which results in the accumulation of TiC in the front. However this phenomenon is not obvious when the particle extent is more than 6%. Meanwhile， the solidification velocity of composites decrease with the increasing of the TiC particle content.
Key words: TiCp/Zn-10Al； composites； directional solidification； solidification velocity
