(大連理工大學鑄造工程研究中心，大連116023)
摘 要: 將實驗得到的初始凝固坯殼的形狀與數值模擬結果相結合的反推法確定了內結晶器冷卻水量與內結晶器側壁換熱系數之間的關系，模擬了冷卻水流量為80、100、120 L/s時凝固坯殼的形狀和位置；在模擬得到的固-液界面位置附近，即距液面5~20 mm處施加了頻率為2 500 Hz的電磁場。結果表明：與傳統連鑄方法相比，施加電磁場后空心管坯的質量得到了明顯的改善。
關鍵字: 電磁連續鑄造；空心管坯；熱交換系數
of hollow billets
（ Engineering Research Center of Foundry,
Dalian University of Technology, Dalian 116023, China）
Abstract: The relationship between the cooling water flow rate and the heat transfer coefficient at the billet/core interface was built up via the trial-and-error approach. The position and shape of the initial solidified shell were predicted by the numerical simulation when the cooling water flow rate is 80,100 and 120 L/s. The electromagnetic field with the frequency of 2 500 Hz was imposed to the position of liquid/solid interface which was 5-20 mm close to the liquid level. The results show that comparing with the conventional continuous cast one, the electromagnetic cast has obviously improved billet quality.
Key words: electromagnetic continuous casting; hollow billet; heat transfer coefficient
