(1. 東北大學 材料與冶金學院， 沈陽 110004；
2. 東北大學 軋制技術及連軋自動化國家重點實驗室， 沈陽 110004)
摘 要: 研究了采用軋制復合方法生產不銹鋼-3003鋁合金蜂窩夾芯板的工藝。 結果表明： 經過表面清理的面板和芯板， 在加熱至500~550℃后進行軋制復合， 在變形率為25%以上時即可以實現牢固的初結合， 面板與芯板間的結合主要依靠“裂口機制”； 軋制過程中芯板上的圓孔出現了類似于墩粗的情況， 為使芯板上孔系能夠發揮作用， 軋制變形率應當控制在25%~40％之間； 經過退火熱處理后， 夾芯板的抗拉強度、 彎曲強度和延伸率等力學性能均達到相關產品標準。
關鍵字: 不銹鋼-3003鋁合金; 軋制復合; 蜂窩夾芯板; 裂口機制; 變形率
YU Jiu-ming2, WEN Jing-lin1
（ 1. School of Materials and Metallurgy,
Northeastern University, Shenyang 110004, China;
2. State Key Laboratory of Rolling Technology and Automation,
Northeastern University, Shenyang 110004, China）
Abstract: The roll-bonding technology of stainless steel/3003 aluminum alloy honeycomb sandwich panel was studied. The results show that the skin and core plate whose surfaces are cleaned can realize excellent interface bonding when deformation rate exceeds 25% and temperature rangs from 500 to 550 ℃. The bonding way between both base metal is typically the split mechanism. And round holes of core plate appear bore-out-of-round during the course of roll-bonding. In order to make full use of the holes in the core plate, deformation rate of 25%-40% is demanded. The tensile strength, flexural strength and elongation of sandwich board all meet the correlative criteria after annealing heat treated.
Key words: stainless steel/3003 aluminum alloy; roll-bonding; honeycomb sandwich panel; split mechanism; deformation rate
