(哈爾濱工業大學 現代焊接生產技術國家重點實驗室，
哈爾濱 150001)
摘 要: 以Ti-6Al-4V薄板材料為研究對象， 研究了激光彎曲成形技術在鈦合金上的應用特征。通過實驗描述了不同掃描參數對彎曲角的影響規律， 并對多次掃描下的板材彎曲動態特性進行了研究。 結果表明： 彎曲角隨掃描次數呈近似的線性增加關系； 在掃描次數一定的情況下，存在一個最優的累積線能量使彎曲角達到最大； 不同的材料狀態在加熱和冷卻過程呈現出不同的彎曲動態特性。 此外， 對激光彎曲后的材料微觀組織、 力學性能進行了測量和分析。結果表明： 掃描參數的選擇對發生相變的區域形狀與相變區組織有較大影響； 多次掃描后， 加熱區材料的強度與硬度均增加， 塑性降低。
關鍵字: 鈦合金； 激光彎曲； 累積線能量； 微觀組織
（State Key Laboratory of Advanced Welding and Production Technology,
Harbin Institute of Technology, Harbin 150001, China）
Abstract: Laser forming technology was employed in bending of Ti-6Al-4V sheets and the process characteristic was investigated. The influence of different laser scanning parameters on bending angle and the process dynamic behaviors were analyzed. The results indicate that the increase of bending angle with the scanning numbers is almost linear. Under the constant bending times, the biggest bending angle can be obtained with an optimal accumulative line energy value. Different dynamic bending behaviors with different material states during the heating and cooling process were observed. Moreover, the microstructure and the mechanical property of the material in heated area were measured and analyzed. The results show that the geometry and the microstructure of phase change zone are affected by scanning parameters, and the material tensile strength and hardness in heated area increase, while the plastic property decreases.
Key words: titanium alloy; laser bending; accumulative line energy; microstructure
