(1. 中南大學 材料科學與工程學院， 長沙410083；
2. 中南大學 有色金屬材料科學與工程教育部重點實驗室， 長沙410083)
摘 要: 采用熱模擬實驗對Al-Cu-Mg-Ag耐熱鋁合金進行熱壓縮實驗，研究合金在熱壓縮變形中的流變應力行為和變形組織。結果表明：Al-Cu-Mg-Ag耐熱鋁合金在熱壓縮變形中的流變應力隨著溫度的升高而減小，隨著應變速率的增大而增大；該合金的熱壓縮變形流變應力行為可用雙曲正弦形式的本構方程來描述，其變形激活能為196.27 kJ/mol；在變形溫度較高或應變速率較低的合金中發生部分再結晶，并且在合金組織中存在大量的位錯和亞晶；隨著溫度的升高和應變速率的降低，合金中拉長的晶粒發生粗化，亞晶尺寸增大，位錯密度減小，合金的主要軟化機制逐步由動態回復轉變?yōu)閯?dòng)態再結晶。
關鍵字: Al-Cu-Mg-Ag合金；耐熱鋁合金；熱壓縮變形；流變應力
Al-Cu-Mg-Ag alloy during hot compression deformation
（1. School of Materials Science and Engineering, Central South University, Changsha 410083, China;
2. The Key Laboratory of Nonferrous Materials Science and Engineering of Ministry of Education, Central South University, Changsha 410083, China）
Abstract: The behavior of the flow stress and the deformation microstructure of heat-resistant aluminum alloy Al-Cu-Mg-Ag during hot compression deformation were studied by thermal simulation test. The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.
Key words: Al-Cu-Mg-Ag alloy; heat-resistant aluminum alloy; hot compression deformation; flow stress
