(東北大學 材料與冶金學院，沈陽 110004)
摘 要: 使用DEFORM-3D軟件模擬等通道轉角擠壓過程中外轉角半徑及背壓對純鈦應力和應變分布的影響，探討不同 R值對材料流動的影響規律。結果顯示：當R = 6 mm時，工件上下表面應力狀況較為平衡，從而得到均勻的等效應變分布；當R＜6 mm時，在外轉角形成的死區使材料之間相互搓動，導致工件底部區域出現劇烈畸變，工件不同區域之間的等效應變量差別較大；當R＞6 mm時，工件上表面與模具內轉角之間的相互作用力增加，使工件頂部變形加劇并導致工件等效應變量不均勻；施加背壓(pb)后，能有效提高等效應變量；適當?shù)?I>R值與pb匹配可使工件得到均勻的應變分布。
關鍵字: 等通道轉角擠壓；外轉角半徑；數值模擬；背壓；純鈦
（School of Materials and Metallurgy, Northeastern University, Shanyang 110004, China）
Abstract:The strain and stress distributions of pure Ti during equal channel angular pressing (ECAP) were simulated by using software of DEFORM-3D with different angular radii and black pressures. The simulated results indicate that the friction forces in the upper and bottom regions can be balanced and the homogeneous equivalent strain distribution can be obtained when R=6 mm. When R＜6 mm, the equivalent strain is non-uniform at the bottom of the workpiece, because the death zone makes the materials interact each other, thus induces the bottom of workpiece acutely distorted and makes the value of equivalent strain vary obviously in different regions of workpiece. At R＞6 mm, the friction force interacts between the upper face of workpiece and inner corner angular of die, which makes the upper of the workpiece deform remarkably and induces non-uniform equivalent strain distribution. The back pressure can increase the value of equivalent strain. Besides, uniform strain distribution can also be obtained by adopting reasonable back pressure and outer angular radius.
Key words: equal channel angular pressing; outer angular radius; numerical simulation; back pressure; pure titanium
