(哈爾濱工業大學 材料科學與工程學院，哈爾濱 150001)
摘 要: 利用掃描電鏡、X射線衍射儀和透射電鏡對6 GPa高壓下凝固的Al-9.6%Mg合金的顯微組織以及組織的穩定性進行研究，對高壓亞穩相形成機理進行探討。結果表明：常壓下枝晶間大量存在的Al3Mg2相在高壓凝固時消失，形成另一密排六方結構相；經300 ℃, 11 h時效處理后，組織變得不穩定，六方結構相消失，轉變成穩定的Al3Mg2相，但其形態由常壓下三岔分界形式轉變成團狀，由此推斷該六方結構相為亞穩相；在高壓凝固條件下Mg在Al基體中的固溶度由7.74%增大到11.3%，Al相的晶格常數增加, 在XRD圖中表現為Al相衍射峰左移，但經時效處理后，Al相衍射峰基體又回復到常壓時的位置。
關鍵字: 高壓凝固組織；Al-Mg合金；時效處理
and stability of Al-9.6%Mg alloy
（School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China）
Abstract:The microstructure and its stability were investigated when Al-9.6%Mg alloy was solidified under 6GPa high pressure using SEM, XRD and TEM. The formation mechanism of high pressure metastable phase was discussed. The results show that a hexagonal phase forms under high pressure solidification conditions instead of a great amount of interdendritic Al3Mg2 phases under normal pressure. This phase disappears after aging treatment (300 ℃, 11 h), and they are transformed into the stable Al3Mg2 phase, but its morphology changes from the branching to agglomerate. So it is deduced that the hexagonal phase formed at 6 GPa pressure is a metastable phase. In addition, the solid solubility of Mg in Al matrix increases from 7.74% to 11.3%, and the lattice constant of α(Al) phase also increases, the diffraction peaks of Al move to the left in XRD patterns. However, the position of the diffraction peaks of Al is almost the same as that of normal pressure after aging treatment.
Key words: high pressure solidification microstructure; Al-Mg alloy; aging treatment
