(中南大學 冶金科學與工程學院, 長沙 410083)
摘 要: 使用有限元法建立了300 kA鋁電解槽的焦粒焙燒三維1/4整槽模型，針對目前普遍采用焦粒均勻鋪設方式，對其焦粒焙燒過程的溫度分布與變化特征進行了瞬態數值仿真研究。當前的焦粒焙燒啟動方式存在陰極表面溫差過大、各陰極炭塊隨空間位置不同溫度分布差異過大、端部第1至第3塊陰極炭塊平均溫度低于900 ℃、陰極炭塊和搗固糊升溫速度過快等缺陷。提出在陰極表面從電解槽邊緣向中心依次鋪設電阻率遞增的焦粒層的優化焙燒方案，并進行溫度場仿真計算。結果表明：該優化方案可以使陰極表面溫度分布更加均勻，端部第1至第3塊陰極炭塊表面溫差比優化前降低8％以上，中間第４至第１3塊陰極炭塊表面溫差降低30％以上，陰極炭塊和陰極縫糊平均升溫速度降低12％，該優化方案更有利于減少電解槽的早期破損。
關鍵字: 鋁電解；電熱場；焦粒焙燒；仿真；優化
（School of Metallurgical Science and Engineering, Central South University, Changsha 410083, China）
Abstract:A three-dimensional transient thermo-electric finite element model of 300 kA quarter aluminum reduction cell was developed to study the thermal field of carbon cathode during the heating-up process by using the same resistivity coke bed. Many defects such as high difference in temperature in the cathode, non-uniform temperature among the cathode surface, non-uniform temperature among the cathodes at different positions, the arerage temperature in the end cathode carbon block 1 to 3 lower than 900 ℃ and too fast heating-up rate during the process were found. In order to solve this problem, an optimization using increasing resistivity coke bed from the side of the cell to the center to preheat the cell was carried out. The results show that the temperature difference is decreased by more than 8% at the end cathode carbon block 1 to 3 and that in the center cathode carbon block 4 to13 more than 30%. The heating-up rate is decreased by 12% in cathodes. The risk of early failure of the cell lining can be reduced by this optimum scheme.
Key words: aluminum reduction; thermo-electric field; coke bed preheating; simulation; optimization
