(武漢理工大學 材料科學與工程學院，武漢 430070)
摘 要: 采用化學復合鍍方法制備鎳−磷−鈦酸鉀晶須復合鍍層，用掃描電鏡和金相顯微鏡觀察復合鍍層的表面形貌和斷面結構，用XRD研究時效溫度對鍍層組織結構的影響，并解釋時效溫度對鍍層顯微硬度的影響機制。采用交流阻抗技術和中性鹽霧實驗研究鍍層的耐腐蝕性能。在銷−盤式摩擦磨損試驗機上進行復合鍍層的摩擦磨損性能測試。結果表明：鍍層的顯微硬度隨溫度的變化曲線呈單峰形態，在400 ℃時達到最大值；復合鍍層具有良好的耐腐蝕性能和摩擦磨損性能，在同等實驗條件下，復合鍍層的磨損率只有Ni-P鍍層的1/4。
關鍵字: 鈦酸鉀晶須；化學復合鍍；鍍層性能
（School of Materials Science and Engineering, Wuhan University of Technology, Wuhan 430070, China）
Abstract:Nickel-phosphorus composite coatings containing potassium titanate whisker (PTW) were prepared by electroless plating. The surface morphology and cross-sectional microstructure of the coatings were investigated by scanning electron microscopy and optical metallographic microscopy. The effect of aging temperature on the microstructure of the coatings was studied by XRD, and the effect of aging temperature on microscopic hardness was analyzed. The corrosion behavior of the electroless coatings was examined by electrochemical impedance spectroscopy and neutral salt spray test. The tribological performances of coatings were evaluated by a pin-on-plate wear tester. The results show that the corrosion resistance of composite coating is improved significantly by incorporation of PTW. The composite coatings exhibit higher wear resistance. The wear rate of the composite coating is approximately one-fourth of that of Ni-P coating under the same conditions.
Key words: potassium titanate whisker; electroless composite plating; coating property
