Abstract:The microstructure, tensile properties and fractography of A356 alloy were studied under as-cast and T6 conditions obtained with expendable pattern shell casting, and the results were compared with lost foam casting (LFC). The results indicate that α(Al) primary, eutectic silicon and Mg₂Si are the main phases in the microstructure of A356 alloy obtained with this casting process. The eutectic silicon particles are spheroidized and uniformly distributed at the grain boundaries after T6 treatment. The average length, average width and aspect ratio of eutectic silicon particles after T6 condition decrease. The sizes of α(Al) primary phase and eutectic silicon of this casting process are smaller than those of LFC. The tensile strength, elongation and hardness of A356 alloy after T6 obviously increase, they reach 260.53 MPa, 6.15% and 86.0, respectively and have a significant improvement compared to LFC. The fracture surfaces of expendable pattern shell casting show a mixed quasi-cleavage and dimple fracture morphology as a transgranular fracture nature. However, the fracture surfaces of LFC display a brittle fracture.

Key words: A356; microstructure; tensile properties; fracture surface; dimple fracture; brittle fracture; expendable pattern shell casting