Abstract:The microstructure and tensile properties of the Mg-1.0%Sn-xY(x=1.5%, 3.0%, 3.5%, atom fraction) alloys extruded indirectly at 350 ˚C were investigated by means of optical microscopy, scanning electron microscopy and tensile test. The mean grain sizes of α-Mg matrix in the three extruded alloys are 6, 8 and 12 μm, respectively, slightly increasing with the addition of Y. The relationship between microstructure and strength was discussed in detail. The results show that the addition of Y has little effect on the grain refinement of the as-extruded Mg-Sn based alloys above. The only MgSnY phase is detected in the Mg-Sn-1.5%Y alloy, and the Sn₃Y₅ phase in the Mg-Sn-3.5%Y alloy, whereas both of them simultaneously exist in the Mg-Sn-3.0%Y alloy. The particle shape of MgSnY and Sn₃Y₅ phase, inherited from the solidification, has little change before and after hot extrusion. Mg-Sn-3.0%Y alloy has the highest ultimate tensile strength (UTS), 305 MPa, by over 50% compared with that of the other two alloys.

Key words: Mg-Sn-Y alloy; extrusion; microstructure; tensile property