中國(guó)有色金屬學(xué)報(bào)(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 20 No. 4 April 2010 |
cold rolling and their evolutions during tempering
（1. Department of Plasticity Technology, Shanghai Jiaotong University, Shanghai 200030, China;
2. School of Metallurgical Engineering, Xi’an University of Architecture and Technology, Xi’an 710055, China;
3. Department of Materials Science and Engineering, Nanjing University of Science and Technology,
Nanjing 210094, China）
Abstract:A new processing method, equal channel angular pressing (ECAP) plus cold rolling (CR), was applied to producing ultra-fine grained FeCoV alloy. The microstructures of ultra-fine grained FeCoV alloy after ECAP, ECAP plus CR, and the effect of tempering treatment on the microstructure of FeCoV alloy produced by ECAP plus CR were investigated. The results show that an elongated substructure with a width of about 0.3 μm is obtained after four-pass ECAP using Route A. Cold rolling after ECAP cannot change the morphologies of elongated substructure, and it results in higher fraction of high-angle boundaries and higher dislocation density compared with the identical ECAP without rolling. Subsequent tempering for 30 min at 853 K brings about many nano-phases precipitating at subgrain boundaries and insides the grains, and the size of precipitated phase is measured to be about 10 nm. Nano-phases grow up with increasing tempering temperature and equiaxed structure forms at 883 K.
Key words: FeCoV alloy; equal channel angular pressing; cold rolling; ultra-fine grain
